2210 Conveyor Belt Replacement Instructions

  1. Remove end caps from the top of the leg uprights.
  2. Loosen handles on legs and slide the leg assembly off.
  3. With the conveyor horizontal,  remove all side rail screws and slide off side rail. (Use 4mm hex wrench).
  4. Loosen screws on the (2) take-up castings on the side OPPOSITE the motor.  (Use M5 hex wrench, 4 bolts each).
  5. Loosen the tension screws at ends of the loosened take-up castings.  (Use 6mm hex wrench).
  6. Push take-up casting as far forward on the frame as possible and tighten one bolt to prevent slippage.
  7. Turn conveyor on side (with motor side down).
  8. On the underside of the conveyor, slide the belt out from under the frame.
  9. With the conveyor on its side, work the belt up over the take-up castings.
  10. Slide the replacement belt over the take-up castings.
  11. Slide belt under the conveyor frame on the bottom side of the conveyor.
  12. Turn conveyor back to horizontal position.
  13. Loosen the screw holding the take-up casting in place and tension casting out with the tension bolt from frame until the belt is at the proper tension.  (Use 6mm hex wrench).
  14. Run conveyor and check tracking.
  15. Tighten the screws on the sides of the take-up castings.
  16. Slide side rails back onto the conveyor frame and replace and properly tighten all screws.
  17. Replace conveyor back on leg assembly.
  18. If the conveyor is an incline conveyor, make sure the conveyor is re-aligned to proper position and angle.